Fike Rafiki Twinflex 202 0001 Twinflex Fire Alarm Multipoint Detector and Sounder White
Specifiers and installers who choose the Multipoint detector do so secure in the knowledge that the fire detection performance of the detector can be matched to the environment in which it is installed and changed at any time during the lifetime of the installation.
The mode of detection required can be simply set by configuring the DIL switch in the detector electronics module.
All modes are compliant with European detector type specifications, and are suitable for use in installations compliant with BS5839: Part 1: 2002.
MODES OF DETECTION
SMOKE 1
Highly thermally enhanced optical Used where ionisation detectors are normally fitted, especially when there are high ceilings or a risk of free burning fires
SMOKE 2
Thermally enhanced optical Used where optical detectors are normally fitted, when there is a risk of a smouldering fire and for escape routes.
SMOKE 3
Thermally enhanced optical with pulse rejection
Used where optical detectors are normally used in positions exposed to brief concentrations of water vapour or smoke e.g. from a bathroom, kettle etc.
HEAT 1
Rate of rise to 58°C Used where a standard rate of rise detector would normally be used
HEAT 2
Low fixed temperature 58°C Used where a standard fixed temperature heat detector would normally be fitted, suitable for kitchens etc
HEAT 3
High fixed temperature 90°C Used where a high fixed temperature heat detector would normally be fitted, suitable for boiler rooms, commercial kitchens, etc.
SMOKE 2/HEAT 2
A combination mode of SMOKE 2 and HEAT 2 will trigger with either a smoke or heat source.
- Can these detectors be installed to any existing 2 wire conventional systems ?
Hi Gary
The Twinflex detectors can only be installed on Rafiki / Fike conventional fire systems. If you would like to give me a call with the system you have, i can the advise on what make of detectors are suitable.
Keith
-